![]() ![]() Should this be unchecked for Expertmode or did someone do this for some other reason.ĭoes anyone have a default expertmode profile that is setup to restore back to factory settings? Not sure if one loads down on install of tools 2.12. Exit the NCS expert software and disconnect the BMW ICOM hardware. ![]() Press F3 Execute Job to start coding the ECU with factory setting according to your BMW vehicle order (VO) ECU resetting is done. Under VIN/FCS/SA/CHASSIS section one box is unchecked. Choose the ECU your would like to code with factory default options of your car. 6) Make sure under button ‘Individualisierung’ all options are crossed. However, I can't tell if it is correct or the files I got were changed from the default by someone. 3) Save as a new profile (give it a name, like the godfather or something powerful sounding). However I decided to do a comparison between the regular coding profile I have and the Expertmode one I got in all the different sections when you are in the Edit Profile mode and there is one other difference. It looks like the only difference is 1 checkbox that's not selected under the FSW/PSW section (FSW-/PSW-Manipulate with FSW_PSW.MAN) So I read *********'s instructions on how to setup an expertmode one. One ExpertMode one that I can use to revert any module back to factory settings and one I can use to code with. I got so many different profiles from different sources and I'm trying to basically just have 2.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |